Black woven insulation over temperature wire, with clip.
Includes:
Temperature Wire Terminal End
Temperature Wire End
Temperature Wire InsulationINSULATOR SENDING SENSOR WIRING…
Installation may be simplified by using a UH-7 terminal end, or cutting wire at harness and reconnecting.
If old wire is damaged from engine heat, it can also be replaced with the insulation in this manner.
…
Maintain accurate engine temperature readings with this coolant temperature sender/sensor, designed for 1979-1980 Corvettes. This factory-correct sensor ensures reliable transmission of temperature data to your vehicle’s gauge or ECU…
Quality Restoration Parts Replaces Original Gauge Perfectly 12 Volt Operation This all-new temperature gauge will look and work just like the original. It will even display the correct temperature from the signal from the factory…
Best Quality Temperature Sender Wiring Splice In To Replaces Burnt, Fragile Original Includes Correct Green Wire With Correct Gauge Correct Black Heat Insulation Sleeve Electrical Ends And Connectors To Fit All Sender Types: Pin, Threaded…
Stock Replacement Converts Engine Temperature Into Electrical Resistance Needed For Proper Warning Light Reading This stock replacement temperature sender switch is manufactured by GM or by one of its authorized suppliers for use as a…
Stock Replacement Converts Engine Temperature Into Electrical Resistance Needed For Proper Gauge Reading This stock replacement temperature sender switch is manufactured by GM or by one of its authorized suppliers for use as a factory…
Stock Replacement Converts Engine Temperature Into Electrical Resistance Needed For Proper Warning Light Reading This stock replacement temperature sender switch is manufactured by GM or by one of its authorized suppliers for use as a…
The variable resistor kit should correct almost any gauge that reads higher than the actual engine temperature. Install the resistor in line with your temp wire and set it to your engine temperature for gauge accuracy. It has a resistance…
The Engine Coolant Temperature Sender monitors the engine temperature. The engine temperature signal is used by the engine control module to adjust the air/fuel mixture and ignition timing. Male oval connector
81-84 Located in Front…
This stock replacement outside air temperature sensor is manufacturedby GM or by one of its authorized suppliers for use as a factoryreplacement part. You will find the fit, finish and function meets allGM specifications. Using stock…